This season begins with a backyard cedar tree. Using a hand thrown weight bag and a throw line, I set the climbing line, shown above, in a moving or double rope configuration, with a Dan House Rope Sleeve friction saver. The height to the tie-in-point was maybe 40′ to 50′. Did some trial ups and downs, no problem, climbed to the tie-in-point and safely descended on the DRT/Unicender.
The next day, using a different line, I set a slightly higher canopy-tie-in-point at about 60′. Again, using the rope sleeve and with a D-link to capture the climbing line side of the line, together with figure eight on a bite knot on the other end of the rope sleeve, I safely locked it off for an SRT climb. Leaving a long enough tail to reach the ground, enabled a ground base retrieval system for the canopy tie in. I could have easily used a throw line for the retrieval, but the 150′ length of climbing line was more than sufficient in this regard.
I’m comfortable with my gear and confident with my technique, but still fine tuning the overall system. I’ve gained much experience and instruction over the past few years, and am excited to be able to integrate all this into my climbs. I still have a lot to learn and experience, but I am both excited and optimistic.
Last season I focused on reinforcing my basic climbing skills, learning to climb and maneuver with minimal equipment, while relying on the fundamental skills and understanding the importance of properly tying, dressing and setting of knots in various scenarios.
My goals this season are: 1. To get more comfortable and proficient climbing and switching between single-stationary and double-moving ropes using both old-school and more modern mechanical climbing devices. 2. To lanyard in as a secondary tie in and perform limb-walks and maybe a cat rescue or two. 3. To climb one tree, traverse through the canopy from tree to tree and descend down another tree, and 4. To install and enjoy quality R&R in both a hammock and a hanging lounge chair about 100+ feet in the air.